Hola Mili, seguro la van a pasar genial, Al Rey ya se lo ve contento
Francisco es mi hijo. Tiene una enfermedad llamada Síndrome de West. En éste blog pretendo reflejar sus emociones y las mías. Espero que sirva de ayuda a otros padres que tienen los mismos miedos que yo.
Suscribirse a:
Comentarios de la entrada (Atom)
1 comentario:
In this the injection of the plastic is "decoupled" into phases to permit better control of part dimensions and more cycle-to-cycle (commonly called shot-to-shot within the industry) consistency. First the cavity is crammed to approximately 98% full utilizing velocity control. Although the stress must be adequate to permit for the specified speed, stress limitations during this stage are undesirable. This lets workers control part dimensions to within thousandths of an inch or better. Pre-moulded or machined components could be inserted Bike Helmets for Kids into the cavity while the mould is open, allowing the fabric injected within the subsequent cycle to kind and solidify around them.
Publicar un comentario